Combi Offer Includes: PHS Airtight Foam x5, PHS Foam Cleaner x1, PHS Teflon Gun x1 and FREE PHS Protective Eyewear.
PHS AIRTIGHT FOAM
PHS Airtight Foam is formulated to create an airtight, thermal and sound insulating interface between construction components.
Properties
• Adheres to all common building materials, with the exception of polyethylene, silicone, oils and greases, mould release agents, etc.
• Can be processed at temperatures from +5°C to +30°C.
• Hardened foam is elastic, predominantly closed-cell, rot-proof, moisture-proof, temperature-resistant from -50°C to +100°C.
• Resistant to aging, but not to UV radiation.
• Offers excellent thermal and sound insulation values.
Processing
• The adhesive surfaces must be free of dirt, dust and grease.
• Slightly moisten the building connection joint with a water spray.
• The optimal processing temperature is +20° C to +25°C.
• Shake the can thoroughly before use.
• Fill the joint no more than halfway, because the fresh foam expands to 2-3 times the initial volume.
• Foam layers thicker than 5cm in several steps and allow each layer to harden.
• The curing of the foam is supported and accelerated by additional moisture in the substrates (moistening of the substrates).
• For all joints, moistening is recommended after each layer of foam.
• Insufficient supply of moisture or excessive moisture can lead to unwanted shrinkage of the foam.
• Never press the partially hardened foam into the joint.
• Remove fresh foam stains immediately with foam cleaner. This can only be done in the tack-free period. Hardened foam can only be removed with special cleaner or mechanically.
PHS FOAM CLEANER
PHS Foam Cleaner is an organic solvent mixture that removes fresh polyurethane foam and is formulated especially to clean the gun adapter after application.
Application Areas
Cleans uncured foam from surfaces, clothes, window & door frames and prevents foam cure in the gun adapter and aerosol valves.
Instructions
• Before screwing the cleaner onto the gun connector, attach the plastic tube included.
• Shake well and screw the aerosol tightly onto the gun adapter.
• Press the trigger to flush the cleaner through the gun with several short shots for at least 5 seconds.
• Rest for 15 minutes to allow cleaner to work.
• Then flush the gun once more.
• Unscrew and wipe the threads clean.
• If the gun adapter has not been used in more than a week, it should be cleaned.